XRT83VSH38 データシートの表示（PDF） - Exar Corporation

部品番号

コンポーネント説明

一致するリスト

XRT83VSH38

8-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT

Exar Corporation 

REV. 1.0.7

XRT83VSH38

8-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT

SIGNAL NAME

RTIP0

RTIP1

RTIP2

RTIP3

RTIP4

RTIP5

RTIP6

RTIP7

RRING0

RRING1

RRING2

RRING3

RRING4

RRING5

RRING6

RRING7

RXMUTE

RXRES1

RXRES0

RCLKE/

µPTS1

BGA

LEAD #

C1

G1

G18

C18

U1

L1

L18

T18

D1

F1

F18

D18

T1

M1

M18

R18

T12

R10

V10

J16

TYPE

DESCRIPTION

I Receive Differential Tip Input

RTIP is the positive differential input from the line interface. Along with the RRING

signal, these pins should be coupled to a 1:1 transformer for proper operation.

I Receive Differential Ring Input

RRING is the negative differential input from the line interface. Along with the RTIP-

signal, these pins should be coupled to a 1:1 transformer for proper operation.

I Receive Data Muting

Hardware Mode Only

This pin is AND-ed with each of the RLOS functions on a per channel basis. There-

fore, if this pin is pulled "High" and a given channel experiences a loss of signal, then

the RPOS/RNEG output pins are automatically pulled "Low" to prevent data chatter-

ing. To disable this feature, the RxMUTE pin must be pulled "Low".

NOTE: This pin is internally pulled “High” with a 50kΩ resistor

I Receive External Resistor Control Pins

Hardware mode Only

These pins are used in the Receive Internal Impedance mode for unique applica-

tions where an accurate resistor can be used to achieve optimal return loss. When

RxRES[1:0] are used, the LIU automatically sets the internal impedance to match

the line build out. For example: if 240Ω is selected, the LIU chooses an internal

impedance such that the parallel combination equals the impedance chosen by

TERSEL[1:0].

"00" = No External Fixed Resistor

"01" = 240Ω

"10" = 210Ω

"11" = 150Ω

NOTE: These pins are internally pulled “Low” with a 50kΩ resistor. This feature is

available in Host mode by programming the appropriate channel register.

I Receive Clock Edge

Hardware Mode

This pin is used to select which edge of the recovered clock is used to update data to

the receiver on the RPOS/RNEG outputs. By default, data is updated on the risinge

edge. To udpdate data on the falling edge, this pin must be pulled "High".

Host Mode

µPTS[2:1] pins are used to select the type of microprocessor to be used for Host

communication.

"00" = 8051 Intel Asynchronous

"01" = 68K Motorola Asynchronous

NOTE: This pin is internally pulled “Low” with a 50kΩ resistor.

6

Share Link: