XRT83SH314 データシートの表示（PDF） - Exar Corporation
部品番号
コンポーネント説明
一致するリスト
XRT83SH314 Datasheet PDF : 101 Pages
| |||
REV. 1.0.4
MICROPROCESSOR
NAME
DATA7
DATA6
DATA5
DATA4
DATA3
DATA2
DATA1
DATA0
µPTS2
µPTS1
µPTS0
PIN
AA4
AB3
AC3
AA5
Y6
AB4
AC4
AB5
AC23
AB22
AA21
Reset
B22
CS5
B20
CS4
A21
CS3
C20
CS2
D19
CS1
B21
XRT83SH314
14-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT
TYPE
I/O
DESCRIPTION
Bi-directional Data Bus
DATA[7:0] is a bi-directional data bus used for read and write operations.
I
Microprocessor Type Select Input
µPTS[2:0] are used to select the microprocessor type interface.
000 = Intel 68HC11, 8051, 80C188 (Asynchronous)
001 = Motorola 68K (Asynchronous)
111 = Motorola MPC8260, MPC860 Power PC (Synchronous)
I
Hardware Reset Input
Active low signal. When this pin is pulled "Low" for more than 10µS, the inter-
nal registers are set to their default state. See the register description for the
default values.
NOTE: Internally pulled "High" with a 50KΩ resistor.
O
Chip Select Output
The XRT83SH314 can be used to provide the necessary chip selects for up to
5 additional devices by using the 3 MSBs ADDR[10:8] from the 11-Bit address
bus. The LIU allows up to 84-channel applications with only using one chip
select. See the ADDR[10:0] definition in the pin description.
RECEIVER SECTION
NAME
PIN
RxON
AB19
RxTSEL
Y15
TYPE
I
I
DESCRIPTION
Receive On/Off Input
Upon power up, the receivers are powered off. Turning the receivers On or Off
can be selected through the microprocessor interface by programming the
appropriate channel register if the hardware pin is pulled "High". If the hard-
ware pin is pulled "Low", all channels are automatically turned off.
NOTE: Internally pulled "Low" with a 50KΩ resistor.
Receive Termination Control
Upon power up, the receivers are in "High" impedance. Switching to internal
termination can be selected through the microprocessor interface by program-
ming the appropriate channel register. However, to switch control to the hard-
ware pin, RxTCNTL must be programmed to "1" in the appropriate global
register. Once control has been granted to the hardware pin, it must be pulled
"High" to switch to internal termination.
NOTE: Internally pulled "Low" with a 50kΩ resistor.
5
Share Link: 