MX7824KCAG データシートの表示（PDF） - Maxim Integrated

部品番号

コンポーネント説明

一致するリスト

MX7824KCAG

CMOS, High-Speed, 8-Bit ADCs with Multiplexer

Maxim Integrated 

CMOS, High-Speed, 8-Bit ADCs

with Multiplexer

RD

500ns

1000ns

600ns

SETUP TIME REQUIRED

BY THE INTERNAL

COMPARATORS PRIOR TO

STARTING CONVERSION

VIN IS SAMPLED

AND THE FOUR MSBs

ARE LATCHED

VIN IS TRACKED

BY INTERNAL

COMPARATORS

INT GOING LOW

INDICATES THAT

CONVERSION IS

COMPLETE AND

THAT DATA CAN

BE READ

Figure 4. Operating Sequence

does not require microprocessor WAIT states. A READ

operation simultaneously initiates a conversion and

reads the previous conversion result.

Interface Mode 0

Figure 5 shows the timing diagram for Mode 0 opera-

tion. This is used with microprocessors that have WAIT

state capability, whereby a READ instruction is extend-

ed to accommodate slow-memory devices. Taking CS

and RD low latches the analog multiplexer address and

starts a conversion. Data outputs DB0–DB7 remain in

the high-impedance condition until the conversion is

complete.

There are two status outputs: Interrupt (INT) and Ready

(RDY). RDY, an open-drain output (no internal pull-up

device), is connected to the processor’s READY/WAIT

input. RDY goes low on the falling edge of CS and goes

high impedance at the end of the conversion, when the

conversion result appears on the data outputs. If the RDY

output is not required, its external pull-up resistor can be

omitted. INT goes low when the conversion is complete

and returns high on the rising edge of CS or RD.

Interface Mode 1

Mode 1 is designed for applications where the micro-

processor is not forced into a WAIT state. Taking CS

and RD low latches the multiplexer address and starts

a conversion (Figure 6). Data from the previous conver-

sion is immediately read from the outputs (DB0–DB7).

INT goes high at the rising edge of CS or RD and goes

low at the end of the conversion. A second READ oper-

ation is required to read the result of this conversion.

The second READ latches a new multiplexer address

and starts another conversion. A delay of 2.5µs must

be allowed between READ operations. RDY goes low

on the falling edge of CS and goes high impedance at

the rising edge of CS. If RDY is not needed, its external

pull-up resistor can be omitted.

CS

RD

ANALOG

CHANNEL

ADDRESS

RDY

INT

DATA

tCSS

tAS

ADDR

VALID

tAH

tRDY

tCRD

HIGH IMPEDANCE

tCSH

tCSS

tP

tAS

ADDR

VALID

tINTH

tACC2

tDH

DATA

VALID

Figure 5. Mode 0 Timing Diagram

_______________________________________________________________________________________ 7

Share Link: