LFSC3GA25E-7F900I データシートの表示（PDF） - Lattice Semiconductor

部品番号

コンポーネント説明

一致するリスト

LFSC3GA25E-7F900I

LatticeSC/M Family Data Sheet Introduction

Lattice Semiconductor 

Lattice Semiconductor

Architecture

LatticeSC/M Family Data Sheet

PFU Modes of Operation

Slices can be combined within a PFU to form larger functions. Table 2-4 tabulates these modes and documents the

functionality possible at the PFU level.

Table 2-4. PFU Modes of Operation

Logic

LUT 4x8 or

MUX 2x1 x 8

LUT 5x4 or

MUX 4x1 x 4

LUT 6x2 or

MUX 8x1 x 2

LUT 7x1 or

MUX 16x1 x 1

Ripple

2-bit Add x 4

2-bit Sub x 4

2-bit Counter x 4

2-bit Comp x 4

RAM

SPR 16x2 x 4

DPR 16x2 x 2

SPR 16x4 x 2

DPR 16x4 x 1

SPR 16x8 x 1

ROM

ROM 16x1 x 8

ROM 16x2 x 4

ROM 16x4 x 2

ROM 16x8 x1

Routing

There are many resources provided in the LatticeSC devices to route signals individually or as busses with related

control signals. The routing resources consist of switching circuitry, buffers and metal interconnect (routing) seg-

ments.

The inter-PFU connections are made with x1 (spans two PFU), x2 (spans three PFU) and x6 (spans seven PFU)

resources. The x1 and x2 connections provide fast and efficient connections in horizontal, vertical and diagonal

directions. All connections are buffered to ensure high-speed operation even with long high-fanout connections.

The ispLEVER design tool takes the output of the synthesis tool and places and routes the design. Generally, the

place and route tool is completely automatic, although an interactive routing editor is available to optimize the

design.

sysCLOCK Network

The LatticeSC devices have three distinct clock networks for use in distributing high-performance clocks within the

device: primary clocks, secondary clocks and edge clocks. In addition to these dedicated clock networks, users are

free to route clocks within the device using the general purpose routing. Figure 2-4 shows the clock resources

available to each slice.

Figure 2-4. Slice Clock Selection

Primary Clock

12

Secondary Clock

6

Routing

GND

Clock to Slice

Note: GND is available to switch off the network.

Primary Clock Sources

LatticeSC devices have a wide variety of primary clock sources available. Primary clocks sources consists of the

following:

• Primary clock input pins

• Edge clock input pins

• Two outputs per DLL

2-6

Share Link: