MAAP-000077-MCH000 データシートの表示（PDF） - Tyco Electronics
部品番号
コンポーネント説明
一致するリスト
MAAP-000077-MCH000 Datasheet PDF : 8 Pages
| |||
Amplifier, Power, 13W
0.7-2.5 GHz
Recommended Layout and Wire Bonding Configuration
MAAP-000077-PED000
Rev —
Preliminary Datasheet
In implementing the DC/ RF crossover shown, the following rules must applied.
1. the DC crossovers should approach and cross the RF trace at a 90 degree angle;
2. the printed DC traces that approach the RF line should be stopped 2 substrate heights from the RF line edge;
3. the rated current capability of the DC crossovers should be greater than the maximum current of the device; and
4. the wires or ribbons used to make the DC crossovers should clear the RF trace by ~ 1 substrate height.
Power Supply Sequencing:
Must apply negative bias to VGG before applying positive bias to VDD to prevent damage to amplifier.
Die Handling:
Refer to Application Note AN3016. All Application Notes may be accessed by going to http://www.macom.com/
Application%20Notes/index.htm.
7
M/A-COM Inc. and its affiliates reserve the right to make changes to the
product(s) or information contained herein without notice. M/A-COM makes
no warranty, representation or guarantee regarding the suitability of its
products for any particular purpose, nor does M/A-COM assume any liability
whatsoever arising out of the use or application of any product(s) or
information.
• North America Tel: 800.366.2266 / Fax: 978.366.2266
• Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300
• Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298
Visit www.macom.com for additional data sheets and product information.
Share Link: 