AD9552 データシートの表示（PDF） - Analog Devices

部品番号

コンポーネント説明

一致するリスト

AD9552

Oscillator Frequency Upconverter

Analog Devices 

Data Sheet

AD9552

APPLICATIONS INFORMATION

THERMAL PERFORMANCE

Table 13. Thermal Parameters for the 32-Lead LFCSP Package

Symbol Thermal Characteristic Using a JEDEC51-7 Plus JEDEC51-5 2S2P Test Board1

θJA

Junction-to-ambient thermal resistance, 0.0 m/sec airflow per JEDEC JESD51-2 (still air)

θJMA

Junction-to-ambient thermal resistance, 1.0 m/sec airflow per JEDEC JESD51-6 (moving air)

θJMA

Junction-to-ambient thermal resistance, 2.5 m/sec airflow per JEDEC JESD51-6 (moving air)

θJB

Junction-to-board thermal resistance, 1.0 m/sec airflow per JEDEC JESD51-8 (moving air)

θJC

Junction-to-case thermal resistance (die-to-heat sink) per MIL-Std 883, Method 1012.1

ΨJT

Junction-to-top-of-package characterization parameter, 0 m/sec airflow per JEDEC JESD51-2 (still air)

Value2

40.5

35.4

31.8

23.3

4.2

0.4

Unit

°C/W

°C/W

°C/W

°C/W

°C/W

°C/W

1 The exposed pad on the bottom of the package must be soldered to ground to achieve the specified thermal performance.

2 Results are from simulations. The PCB is a JEDEC multilayer type. Thermal performance for actual applications requires careful inspection of the conditions in the

application to determine whether they are similar to those assumed in these calculations.

The AD9552 is specified for an ambient temperature (TA). To

ensure that TA is not exceeded, an airflow source can be used.

Use the following equation to determine the junction tempera-

ture on the application PCB:

TJ = TCASE + (ΨJT × PD)

where:

TJ is the junction temperature (°C).

TCASE is the case temperature (°C) measured by the customer

at the top center of the package.

ΨJT is the value indicated in Table 13.

PD is the power dissipation (see the Specifications section).

Values of θJA are provided for package comparison and PCB design

considerations. θJA can be used for a first-order approximation

of TJ using the following equation:

TJ = TA + (θJA × PD)

where TA is the ambient temperature (°C).

Values of θJC are provided for package comparison and PCB

design considerations when an external heat sink is required.

Values of θJB are provided for package comparison and PCB

design considerations.

Rev. E | Page 19 of 32

Share Link: