MA730 データシートの表示（PDF） - Monolithic Power Systems

部品番号

コンポーネント説明

一致するリスト

MA730

Rotary Knob Kit for the MagAlpha

Monolithic Power Systems 

EVKT-KNOB – ROTARY KNOB KIT FOR THE MAGALPHA

MAGNETIC FIELD

A NdFeB cylinder magnet is mounted at the end of the aluminum shaft.

Table 6: Magnet Characteristics

Material

Remanence (Br)

Diameter

Height

Magnetization

NdFeB (N35 or N35H)

1.2T

5mm

2.5mm

Diametrical

How to Change the Mechanical Zero

Unscrew the knob with a Hex key 1/16”. Hold the shaft with a pin inserted in the 2mm diameter hole and

rotate the knob to the desired position. When tightening the screw, ensure that the shaft is fully inserted.

Note that the zero position can also be adjusted through programming, as described in the MagAlpha

datasheet.

Figure 13: Adjusting the Magnet Angular Position

How to Change the Magnetic Field Amplitude

The performance of the MagAlpha remains the same from 75mT to 150mT and higher (the MagAlpha

has no maximum operating field). The critical region is the lower end of the specified range. Some

parameters (i.e.: noise, linearity) deteriorate gradually when the magnetic field becomes weak. The two

spacers enclosed in this evaluation kit allow the sensor (the noise level in particular) to be tested at low

magnetic fields.

Figure 14: Magnetic Field vs. Air Gap for the Supplied Magnet

EVKT-KNOB

www.MonolithicPower.com

9

12/10/2018

MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.

© 2018 MPS. All Rights Reserved.

Share Link: