MP62130EK データシートの表示（PDF） - Monolithic Power Systems

部品番号

コンポーネント説明

一致するリスト

MP62130EK

3.3V/5V, Single-Channel 500mA Current-Limited Power Distribution Switch with Output Discharge

Monolithic Power Systems 

MP62130/MP62131 –CURRENT-LIMITED POWER DISTRIBUTION SWITCH

DETAILED DESCRIPTION

Over Current

When the load exceeds trip current (minimum

threshold current triggering constant-current

mode) or a short is present, MP62130/MP62131

switches into to a constant-current mode (current

limit value). MP62130/MP62131 will be shutdown

only if the overcurrent condition stays long

enough to trigger thermal protection.

Trigger overcurrent protection for different

overload conditions occurring in applications:

1) The output has been shorted or overloaded

before the device is enabled or input applied.

MP62130/MP62131 detects the short or

overload and immediately switches into a

constant-current mode.

2) A short or an overload occurs after the device

is enabled. After the current-limit circuit has

been tripped (reached the trip current

threshold), the device switches into constant-

current mode. However, high current may

flow for a short period of time before the

current-limit circuit can react.

3) Output current has been gradually increased

beyond the recommended operating current.

The load current rises until the trip current

threshold is reached or until the thermal limit

of the device is exceeded. The

MP62130/MP62131 is capable of delivering

current up to the trip current threshold without

damaging the device. Once the trip threshold

has been reached, the device switches into

its constant-current mode.

Flag Response

The FLAG pin is an open drain configuration.

This FAULT will report a fail mode after an 8ms

deglitch timeout. This is used to ensure that no

false fault signals are reported. This internal

deglitch circuit eliminates the need for extend

components. The FLAG pin is not deglitched

during an over temperature or voltage lockout.

Thermal Protection

The purpose of thermal protection is to prevent

damage in the IC by allowing exceptive current to

flow and heating the junction. The die

temperature is internally monitored until the

thermal limit is reached. Once this temperature is

reached, the switch will turn off and allow the

chip to cool. The switch has a built-in hysteresis.

Under-Voltage Lockout (UVLO)

This circuit is used to monitor the input voltage to

ensure that the MP62130/MP62131 is operating

correctly. This UVLO circuit also ensures that

there is no operation until the input voltage

reaches the minimum spec.

Enable

The logic pin disables the chip to reduce the

supply current. The device will operate once the

enable signal reaches the appropriate level. The

input is compatible with both COMS and TTL.

Output Discharge

The part involves a discharge function that

provides a resistive discharge path for the

external output capacitor. The function will be

active when the part is disabled (Input voltage is

under UVLO or enable is deasserted) and it will

be done in a very limited time.

MP62130/MP62131 Rev. 0.9

www.MonolithicPower.com

9

6/15/2010

MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.

© 2010 MPS. All Rights Reserved.

Share Link: