FAN5354 データシートの表示（PDF） - ON Semiconductor
部品番号
コンポーネント説明
一致するリスト
FAN5354 Datasheet PDF : 16 Pages
| |||
Table 1. Recommended External Components for 3 A Maximum Load Current
Component
Description
Vendor
Parameter Typ.
Units
L1
COUT
CIN
470 nH Nominal
2 Pieces
10 F, 6.3 V, X5R, 0805
10 F, 6.3 V, X5R, 0805
IHLP1616ABER47M01 (Vishay)
SD12-R47-R (Coiltronics)
VLC5020T-R47N (TDK)
(TDK)
LQH55PNR47NT0 (Murata)
GRM21BR60J106M (Murata)
C2012X5R0J106M (TDK)
L
0.47
H
DCR
20
m
C
10.0
F
CIN1
10 nF, 25 V, X7R, 0402
GRM155R71E103K (Murata)
C1005X7R1E103K (TDK)
C
10
nF
CVCC
4.7 F, 6.3 V, X5R, 0603
GRM188R60J475K (Murata)
C1608X5R0J475K (TDK)
C
4.7
F
R3(1)
Resistor: 1 0402
Any
R
1
Note:
1. R3 is optional and improves IC power supply noise rejection. See Layout recommendations for more information.
Pin Configuration
FB 1
VOUT 2
PGND 3
PGND 4
SW 5
SW 6
P1
(GND)
12 MODE
11 PGOOD
10 EN
9 VCC
8 PVIN
7 PVIN
Figure 2. 12-Pin, 3 x 3.5 mm MLP (Top View)
Pin Definitions
Pin # Name Description
1
FB FB. Connect to resistor divider. The IC regulates this pin to 0.8 V.
2
VOUT VOUT. Sense pin for VOUT. Connect to COUT.
3, 4
PGND
Power Ground. Low-side MOSFET is referenced to this pin. CIN and COUT should be returned with a
minimal path to these pins.
5, 6
SW Switching Node. Connect to inductor.
P1
GND Ground. All signals are referenced to this pin.(2)
7, 8
PVIN Power Input Voltage. Connect to input power source. Connect to CIN with minimal path.
9
VCC
IC Bias Supply. Connect to input power source. Use a separate bypass capacitor CVCC from this pin to
the P1 GND terminal between pins 1 and 12.
10
EN Enable. The device is in shutdown mode when this pin is LOW. Do not leave this pin floating.
11 PGOOD Power Good. This open-drain pin pulls LOW if the output falls out of regulation or is in soft-start.
MODE / Sync. A logic 0 allows the IC to automatically switch to PFM during light loads. When held
12
MODE HIGH, the IC to stays in PWM mode. The regulator also synchronizes its switching frequency to the
frequency provided on this pin. Do not leave this pin floating.
Note:
2. P1 is the bottom heat-sink pad. Ground plane should flow through pins 3, 4, and P1 and can be extended through pin 11 if
PGOOD’s function is not required, and through pin 12 if MODE is to be grounded, to improve IC cooling.
© 2009 Fairchild Semiconductor Corporation
FAN5354 • Rev. 1.0.7
2
www.fairchildsemi.com
Share Link: 