CMX860D6 データシートの表示（PDF） - MX-COM Inc

部品番号

コンポーネント説明

一致するリスト

CMX860D6

Telephone Signaling Transceiver

MX-COM Inc  

Telephone Signaling Transceiver

10

CMX860 Advance Information

Note, that the circuit will also respond to a telephone line voltage reversal. If necessary, the µC can

distinguish between a Ring signal and a line voltage reversal by measuring the time that bit 14 of the Status

Register (Ring Detect) is high.

If the Ring detect function is not used then pin RD should be connected to DVSS and RT to DVDD.

3.2 Hook Detector Interface

This is identical internally to the Ring Detector interface circuit and similar components could be used

externally, with appropriate values, if hook detection is to be performed by detecting a voltage change across

the tip and ring lines to the local phone.

3.3 Line Interface

Figure 5: 2-Wire Line Interface Circuit: Application Circuits are TBD

3.4 Phone Interface

Figure 6: 2-Wire Phone Interface Circuit: Application Circuits are TBD

3.5 RESET

When this pin is taken low, it performs the same operation as a C-BUS General Reset command.

Consequently, the device will enter the powered-saved mode. Refer to section 4.12.1 for further information.

ã2000 MX-COM, Inc.

www.mxcom.com tel: 800 638 5577 336 744 5050 fax: 336 744 5054

Doc. # 20480222.002

4800 Bethania Station Road, Winston-Salem, NC 27105-1201 USA All trademarks and service marks are held by their respective companies.

Share Link: