HMC1018LP4E データシートの表示（PDF） - Hittite Microwave
部品番号
コンポーネント説明
一致するリスト
HMC1018LP4E Datasheet PDF : 10 Pages
| |||
HMC1018LP4E
v01.1211
1.0 dB LSB GaAs MMIC 5-BIT DIGITAL
ATTENUATOR, 0.1 - 30 GHz
Serial Control Interface
The HMC1018LP4E contains a 3-wire SPI compatible digital interface (SERIN, CLK, LE). The serial control interface
is activated when S/A is kept high. The 5-bit serial word must be loaded MSB first as a 6-bit word with the first
bit ignored. The positive-edge sensitive CLK and LE requires clean transitions. If mechanical switches are used,
sufficient debouncing should be provided. When LE is high, 5-bit data in the serial input register is transferred to the
attenuator. When LE is high CLK is masked to prevent data transition during output loading.
For all modes of operations, the state will stay constant while LE is kept low.
Serial Mode Truth Table
P4
16 dB
Control Voltage Input
P3
8 dB
P2
4 dB
P1
2 dB
P0
1 dB
Attenuation
State
RF1 - RF2
High High High High High Reference I.L.
High High High High
Low
1 dB
High High High Low
High
2 dB
High High
Low
High
High
4 dB
High
Low
High High
High
8 dB
Low High High High High
16 dB
Low
Low
Low
Low
Low
31 dB
Any combination of the above states will provide an attenuation
approximately equal to the sum of the bits selected.
Parameter
Typ.
Min. serial period, tSCK
Control set-up time, tCS
Control hold-time, tCH
LE setup-time, tLN
Min. LE pulse width, tLEW
Min LE pulse spacing, tLES
Serial clock hold-time from LE, tCKN
Hold Time, tPH.
Latch Enable Minimum Width, tLEN
Setup Time, tPS
100 ns
20 ns
20 ns
10 ns
10 ns
630 ns
10 ns
0 ns
10 ns
2 ns
Asynchronous Mode
The HMC1018LP4E can be switched to an asynchronous mode to change the attenuation state rapidly to one of four
predefined states. The logic state of ASM1-ASM2 determines one of the four attenuation states in the asynchronous
mode per truth table. The asynchronous mode works either directly or latched. To activate the direct-asynchronous-
mode, S/A needs to be at logic low and LE needs to be at logic high. In the direct-asynchronous-mode, any change in
the logic state of ASM1-ASM2 directly affects the attenuation state. In the latched-asynchronous-mode, the attenuation
state changes per the asynchronous mode truth table when S/A is at logic low and LE is pulsed per the timing diagram.
The attenuation stays constant (latched) as long as LE stays low. In the asynchronous mode, the inputs SERIN and
CLK do not affect the attenuation state.
For price, delivery and to place orders: Hittite Microwave Corporation, 2 Elizabeth Drive, Chelmsford, MA 01824
Phone: 978-250-3343 Fax: 978-250-3373 Order On-line at www.hittite.com
4
Application Support: Phone: 978-250-3343 or apps@hittite.com
Share Link: 