MP1584 データシートの表示（PDF） - Monolithic Power Systems

部品番号

コンポーネント説明

一致するリスト

MP1584

3A, 1.5MHz, 28V Step-Down Converter

Monolithic Power Systems 

MP1584 – 3A, 1.5MHz, 28V STEP-DOWN CONVERTER

At higher duty cycle operation condition, the

time period available to the bootstrap charging

is less so the bootstrap capacitor may not be

sufficiently charged.

In case the internal circuit does not have

sufficient voltage and the bootstrap capacitor is

not charged, extra external circuitry can be

used to ensure the bootstrap voltage is in the

normal operational region. Refer to External

Bootstrap Diode in Application section.

The DC quiescent current of the floating driver

is about 20µA. Make sure the bleeding current

at the SW node is higher than this value, such

that:

IO



VO

(R1  R2)



20A

Current Comparator and Current Limit

The power MOSFET current is accurately

sensed via a current sense MOSFET. It is then

fed to the high speed current comparator for the

current mode control purpose. The current

comparator takes this sensed current as one of

its inputs. When the power MOSFET is turned

on, the comparator is first blanked till the end of

the turn-on transition to avoid noise issues. The

comparator then compares the power switch

current with the COMP voltage. When the

sensed current is higher than the COMP

voltage, the comparator output is low, turning

off the power MOSFET. The cycle-by-cycle

maximum current of the internal power

MOSFET is internally limited.

Startup and Shutdown

If both VIN and EN are higher than their

appropriate thresholds, the chip starts. The

reference block starts first, generating stable

reference voltage and currents, and then the

internal regulator is enabled. The regulator

provides stable supply for the remaining

circuitries.

While the internal supply rail is up, an internal

timer holds the power MOSFET OFF for about

50µs to blank the startup glitches. When the

internal soft-start block is enabled, it first holds

its SS output low to ensure the remaining

circuitries are ready and then slowly ramps up.

Three events can shut down the chip: EN low,

VIN low and thermal shutdown. In the shutdown

procedure, power MOSFET is turned off first to

avoid any fault triggering. The COMP voltage

and the internal supply rail are then pulled

down.

Programmable Oscillator

The MP1584 oscillating frequency is set by an

external resistor, Rfreq from the FREQ pin to

ground. The value of Rfreq can be calculated

from:

  Rfreq(k) 

180000

fs (kHz) 1.1

MP1584 Rev. 1.0

www.MonolithicPower.com

9

8/8/2011

MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.

© 2011 MPS. All Rights Reserved.

Share Link: