DF12(3.0)-32DP-0.5V(86) データシートの表示（PDF） - HIROSE ELECTRIC

部品番号

コンポーネント説明

一致するリスト

DF12(3.0)-32DP-0.5V(86)

0.5mm Pitch SMT Board to Board Connector

HIROSE ELECTRIC 

The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.

All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose websitDe FRo1H2S sSeaerrciheastqww0w.5.hmiromse-cPonitncechtoSrsM.coTm,BorocaonrtdacttoyoBuroHairrodseCsaolensnreepcretsoenrtative.

BPrecautions for Use

1.Recommended Temperature Profile (SMT)

Temperature (ç)

250

200

150 150ç

250ç

220ç

180ç

60sec max

Soldering

100

90 to 120sec

Preheating

50

Room

temperature

0

50

100 150 200 250 300

Time (sec)

Note1: UP to 2 cycles of Reflow soldering are possible under the

same conditions, provided that there is a return to normal

temperature between the first and second cycle.

Note2: The temperature profile indicates the board surface

temperature at the point of contacts with the connector

terminals.

2.Recommended Manual Soldering Condition (SMT) Soldering iron temperature: 350ç, Soldering time: Within 3 seconds

3.Recommended Screen Thickness and 0.12mm

open area ratio(Pattern area ratio)

Open area ratio: 70%

4.Board Warp(SMT)

Maxmum 0.02mm in the connector center area, based on both connector edges

5.Cleaning Condition

Refer to "Nylon Connector Use Hand book".

6.Cautions

s The receptacle is designed in a structure where contacts are exposed. Touching it with

bare hands would cause contact failure or electrostatic element damage.

s Where no board is mounted, the insertion or extraction will cause damage or

contact deformation.

s Avoid retaining the board with the connector only, and fix the board by any other means

than the connector.

s Excessive scoop insertion or extraction may result in damage.

s In the manual soldering process, don't carry out the flux coating which will cause a flux

blister on the connector.

s The color phase of this product may be slightly different from that of the formed product

according to the manufacturing lot. However, the difference doesn't affect the performance.

A203

Share Link: