TSL2562 データシートの表示（PDF） - TEXAS ADVANCED OPTOELECTRONIC SOLUTIONS

部品番号

コンポーネント説明

一致するリスト

TSL2562

LOW-VOLTAGE LIGHT-TO-DIGITAL CONVERTER

TEXAS ADVANCED OPTOELECTRONIC SOLUTIONS 

TSL2562, TSL2563

LOW-VOLTAGE

LIGHT-TO-DIGITAL CONVERTER

TAOS066N − AUGUST 2010

NOTES: 2. Optical measurements are made using small-angle incident radiation from light-emitting diode optical sources. Visible 640 nm LEDs

and infrared 940 nm LEDs are used for final product testing for compatibility with high-volume production.

3. The 640 nm irradiance Ee is supplied by an AlInGaP light-emitting diode with the following characteristics: peak wavelength

λp = 640 nm and spectral halfwidth Δλ½ = 17 nm.

4. The 940 nm irradiance Ee is supplied by a GaAs light-emitting diode with the following characteristics: peak wavelength

λp = 940 nm and spectral halfwidth Δλ½ = 40 nm.

5. Integration time Tint, is dependent on internal oscillator frequency (fosc) and on the integration field value in the timing register as

described in the Register Set section. For nominal fosc = 735 kHz, nominal Tint = (number of clock cycles)/fosc.

Field value 00: Tint = (11 × 918)/fosc = 13.7 ms

Field value 01: Tint = (81 × 918)/fosc = 101 ms

Field value 10: Tint = (322 × 918)/fosc = 402 ms

Scaling between integration times vary proportionally as follows: 11/322 = 0.034 (field value 00), 81/322 = 0.252 (field value 01),

and 322/322 = 1 (field value 10).

6. Full scale ADC count value is limited by the fact that there is a maximum of one count per two oscillator frequency periods and also

by a 2-count offset.

Full scale ADC count value = ((number of clock cycles)/2 − 2)

Field value 00: Full scale ADC count value = ((11 × 918)/2 − 2) = 5047

Field value 01: Full scale ADC count value = ((81 × 918)/2 − 2) = 37177

Field value 10: Full scale ADC count value = 65535, which is limited by 16 bit register. This full scale ADC count value is reached

for 131074 clock cycles, which occurs for Tint = 178 ms for nominal fosc = 735 kHz.

7. Low gain mode has 16y lower gain than high gain mode: (1/16 = 0.0625).

8. The sensor Lux is calculated using the empirical formula shown on p. 22 of this data sheet based on measured Ch0 and Ch1 ADC

count values for the light source specified. Actual Lux is obtained with a commercial luxmeter. The range of the (sensor Lux) / (actual

Lux) ratio is estimated based on the variation of the 640 nm and 940 nm optical parameters. Devices are not 100% tested with

fluorescent or incandescent light sources.

The LUMENOLOGY r Company

r

r

www.taosinc.com

Copyright E 2010, TAOS Inc.

5

Share Link: