ST7MDT2-EPB2 データシートの表示（PDF） - STMicroelectronics

部品番号

コンポーネント説明

一致するリスト

ST7MDT2-EPB2

A LOW-COST DEVELOPMENT PACKAGE INCLUDING A FULL REAL-TIME EMULATION BOARD

STMicroelectronics 

ST7 EPB User Manual

2 - Getting Started

2

2.1

2.2

Note:

Note:

GETTING STARTED

Delivery checklist

Check that your ST7 EPB kit contains the following:

• 1 ST7 EPB Eprom Programming Board (i.e. the EPB appropriate to the sales

type ordered).

• 1 power supply.

• 1 parallel cable.

• 1 MCU on CD CDROM containing the Windows® Epromer software.

• 1 10-pin HE10 type ribbon cable for ISP mode (if provided on the programming

board for the sales type ordered).

Setting up the EPB

To set up the ST7 EPB hardware, follow these instructions:

1 Shut down and power-off the host PC.

2 Connect one end of the supplied parallel cable to connector P1 of the ST7 EPB

and the other end to one of the host PC’s parallel ports (LPT1 or LPT2).

Be sure to use the parallel cable provided with your kit—using a longer parallel cable may

cause malfunctions.

Connect the cable directly between the host PC and the programming board—the insertion of

additional cables or switch boxes between the host PC and the programming board may

cause malfunctions.

If a dongle (a hardware key required by some software packages) is already connected to the

PC’s parallel port, it should not interfere with the programming board. However, if a

malfunction of the board should occur, please remove the dongle and restart the above

sequence.

3 Power on the programming board by connecting the power supply to the

programming board and to the mains. Ensure that the power supply is adapted

to the mains voltage and outlet type used in your country.

The board can be supplied from the integrated power supply provided with the board, or from

an external +15 VDC / 0.5 A power supply.

4 Power on the host PC and install the software provided as described in the next

section.

7/20

Share Link: