¡ Semiconductor
MSM7718-01
Direct Access to Default Store Memory (See Figs.8-1, 8-2)
The contents of the default store memory can be
changed (e.g., to change tone detection levels
and tone generation frequencies) in the initial
mode (CR0-B3 to CR0-B0="0000").
Refer to the following procedure:
1.Set the default value store memory address
(CR11, CR12).
Set the write data into CR16 and CR17.
2.When writing data to the upper byte, set the
DMWR (change default) command (CR10-B3
to CR10-B0="1101").
Default Value Store Memory
Direct Access
Set address.
Set write data.
(1) CR12, CR11
CR16, CR17
Set command to
write in upper byte
(DMWR)
(2) CR10
Yes Continue to
write?
No
END
Figure 8-1 Flow Chart of Default Value Store
Memory Direct Access
Default Value Store Memory
Data (CR16, CR17)
Address (CR11, CR12)
Figure 8-2 Memory Map for Default Value Store Memory Direct Access
36/38