EV2364DF-01A データシートの表示（PDF） - Monolithic Power Systems
部品番号
コンポーネント説明
一致するリスト
EV2364DF-01A Datasheet PDF : 12 Pages
| |||
TM
MP2364 — DUAL 1.5A, 23V, 1.4MHz STEP-DOWN CONVERTER
PIN FUNCTIONS (SOIC16)
Pin # Name Description
1
SSA
Soft-Start Control for Channel A. 9kΩ output resistance from the pin. Set RC time constant
with external capacitor for soft start ramp time. Ramp Time = 2.2 x 9kΩ x C.
2
BSA High-Side Driver Boost Pin. Connect a 10nF capacitor from this pin to SWA.
3
INA
Supply Voltage Channel A. The MP2364 operates from a +4.75V to +23V unregulated input.
Input Ceramic Capacitors should be close to this pin.
4
SWA Switch Channel A. This connects the inductor to either INA through M1A or to PGA through M2A.
5 GNDA Ground A.
Feedback Voltage for Channel B. This pin is the feedback voltage. The output voltage is ratio scaled
6
FBB through a voltage divider, and the center point of the divider is connected to this pin. The voltage is
compared to the on board 0.92V reference.
Compensation Channel B. This is the output of the transconductance error amplifier. A series
7 COMPB RC is placed on this pin for proper control loop compensation. Please refer to more in the
datasheet.
Enable/UVLO Channel B. A voltage greater than 2.62V enables operation. Leave ENB
8
ENB
unconnected for automatic startup. An Under Voltage Lockout (UVLO) function can be
implemented by the addition of a resistor divider from VIN to GND. For complete low current
shutdown the ENB pin voltage needs to be less than 700mV.
9
SSB
Soft-Start Control for Channel B. 9kΩ output resistance from the pin. Set RC time constant
with external capacitor for soft start ramp time. Ramp Time = 2.2x9kΩxC.
10
BSB High-Side Driver Boost Pin. Connect a 10nF capacitor from this pin to SWB.
11
INB
Supply Voltage Channel B. The MP2364 operates from a +4.75V to +23V unregulated input.
Input Ceramic Capacitors should be close to this pin.
12 SWB Switch Channel B. This connects the inductor to either INB through M1B or to PGB through M2B.
13 GNDB Ground B.
Feedback Voltage for Channel A. This pin is the feedback voltage. The output voltage is ratio scaled
14
FBA through a voltage divider, and the center point of the divider is connected to this pin. The voltage is
compared to the on board 0.92V reference.
Compensation Channel A. This is the output of the transconductance error amplifier. A series
15 COMPA RC is placed on this pin for proper control loop compensation. Please refer to more in the
datasheet.
Enable/UVLO Channel A. A voltage greater than 2.62V enables operation. Leave ENA
16
ENA
unconnected for automatic startup. An Under Voltage Lockout (UVLO) function can be
implemented by the addition of a resistor divider from VIN to GND. For complete low current
shutdown the ENA pin voltage needs to be less than 700mV.
MP2364 Rev. 1.4
www.MonolithicPower.com
5
3/22/2006
MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.
© 2006 MPS. All Rights Reserved.
Share Link: 