MP2355DN-Z データシートの表示（PDF） - Monolithic Power Systems

部品番号

コンポーネント説明

一致するリスト

MP2355DN-Z

3A, 23V, 380KHz Step-Down Converter

Monolithic Power Systems 

TM

MP2355 – 3A, 23V, 380KHz STEP-DOWN CONVERTER

TYPICAL PERFORMANCE CHARACTERISTICS (continued)

Circuit of Figure 2, VIN = 12V, VO = 3.3V, L1 = 15µH, C1 = 10µF, C2 = 22µF, TA = +25°C, unless

otherwise noted.

Load Transient

VO, AC

200mV/div.

IL

1A/div.

ILOAD

1A/div.

Short Circuit Protection

Short Circuit Recovery

VOUT

2V/div.

VOUT

2V/div.

IL

2A/div.

IL

2A/div.

MP2355-TPC06

MP2355-TPC07

MP2355-TPC08

PIN FUNCTIONS

Pin #

1

2

3

4

5

6

7

8

Name

SS

BST

VIN

LX

GND

FB

COMP

RUN

Description

Soft-Start Control Input. SS controls the soft-start period. Connect a capacitor from SS to

GND to set the soft-start period. A 0.1µF capacitor sets the soft-start period to 10ms. To

disable the soft-start feature, leave SS unconnected.

High-Side Gate Drive Boost Input. BST supplies the drive for the high-side N-Channel

MOSFET switch. Connect a 10nF or greater capacitor from LX to BST to power the high

side switch.

Power Input. VIN supplies the power to the IC, as well as the step-down converter switches.

Drive VIN with a 4.75V to 23V power source. Bypass VIN to GND with a suitably large

capacitor to eliminate noise on the input to the IC. See Input Capacitor

Power Switching Output. LX is the switching node that supplies power to the output.

Connect the output LC filter from LX to the output load. Note that a capacitor is required

from LX to BST to power the high-side switch.

Ground. (Note: Connect the exposed pad on backside to Pin 5.)

Feedback Input. FB senses the output voltage to regulate that voltage. Drive FB with a

resistive voltage divider from the output voltage. The feedback threshold is 1.222V. See

Setting the Output Voltage

Compensation Node. COMP is used to compensate the regulation control loop. Connect a

series RC network from COMP to GND to compensate the regulation control loop. In some

cases, an additional capacitor from COMP to GND is required. See Compensation

Enable/UVLO. A voltage greater than 2.71V enables operation. For complete low current

shutdown the EN pin voltage needs to be less than 900mV.

MP2355 Rev. 1.5

www.MonolithicPower.com

4

5/1/2006

MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.

© 2006 MPS. All Rights Reserved.

Share Link: