MAX338D データシートの表示（PDF） - Maxim Integrated

部品番号

コンポーネント説明

一致するリスト

MAX338D

8-Channel/Dual 4-Channel, Low-Leakage, CMOS Analog Multiplexers

Maxim Integrated 

8-Channel/Dual 4-Channel,

Low-Leakage, CMOS Analog Multiplexers

______________________________________________________________Pin Description

PIN

MAX338

MAX339

DIP/SO/QSOP TQFN-EP DIP/SO/QSOP TQFN-EP

1, 15, 16,

15, 14, 13

—

—

—

—

1, 16

15, 14

2

16

2

16

3

1

3

1

4–7

2–5

—

—

—

—

4–7

2–5

8

6

—

—

—

—

8, 9

6, 7

9–12

7–10

—

—

—

—

10–13

8–11

13

11

14

12

14

12

15

13

—

—

—

—

__________Applications Information

Operation with

Supply Voltages Other than 15V

Using supply voltages less than ±15V will reduce the

analog signal range. The MAX338/MAX339 switches

operate with ±4.5V to ±20V bipolar supplies or with a

+4.5V to +30V single supply. Connect V- to GND when

operating with a single supply. Both device types can

also operate with unbalanced supplies such as +24V

and -5V. The Typical Operating Characteristics graphs

show typical on-resistance with 20V, 15V, 10V, and 5V

supplies. (Switching times increase by a factor of two

or more for operation at 5V.)

Overvoltage Protection

Proper power-supply sequencing is recommended for

all CMOS devices. Do not exceed the absolute maxi-

mum ratings, because stresses beyond the listed rat-

ings may cause permanent damage to the devices.

Always sequence V+ on first, then V-, followed by the

logic inputs NO and COM. If power-supply sequencing

is not possible, add two small signal diodes in series

with supply pins for overvoltage protection (Figure 1).

Adding diodes reduces the analog signal range to 1V

below V+ and 1V above V-, but does not affect the

devices’ low switch resistance and low leakage charac-

teristics. Device operation is unchanged, and the differ-

ence between V+ and V- should not exceed 44V.

NAME

FUNCTION

A0, A2, A1

A0, A1

EN

V-

NO1–NO14

NO1A–NO4A

COM

COMA, COMB

NO8–NO5

NO4B–NO1B

V+

GND

Exposed Pad

Address Inputs

Address Inputs

Enable

Negative-Supply Voltage Input

Analog Inputs—Bidirectional

Analog Inputs—Bidirectional

Analog Output—Bidirectional

Analog Outputs—Bidirectional

Analog Inputs—Bidirectional

Analog Inputs—Bidirectional

Positive-Supply Voltage Input

Ground

Exposed Pad (TQFN only). Connect EP to

V+.

V+

NO

COM

Vg

V-

Figure 1. Overvoltage Protection Using External Blocking

Diodes

6 _______________________________________________________________________________________

Share Link: