M37516E6HP データシートの表示（PDF） - Renesas Electronics

部品番号

コンポーネント説明

一致するリスト

M37516E6HP

SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER

Renesas Electronics 

7516 Group

(3) Standard serial I/O Mode

The standard serial I/O mode inputs and outputs the software

commands, addresses and data needed to operate (read, pro-

gram, erase, etc.) the internal flash memory. This I/O is clock

synchronized serial. This mode requires the exclusive external

equipment (serial programmer).

The standard serial I/O mode is different from the parallel I/O

mode in that the CPU controls flash memory rewrite (uses the

CPU rewrite mode), rewrite data input and so forth. The standard

serial I/O mode is started by connecting “H” to the P26 (SCLK) pin

and “H” to the P41 (INT0) pin and “H” to the CNVSS pin (apply 4.5

V to 5.5 V to Vpp from an external source), and releasing the re-

set operation. (In the ordinary microcomputer mode, set CNVss

pin to “L” level.)

This control program is written in the Boot ROM area when the

product is shipped from Mitsubishi. Accordingly, make note of the

fact that the standard serial I/O mode cannot be used if the Boot

ROM area is rewritten in parallel I/O mode. Figure 65 shows the

pin connection for the standard serial I/O mode.

In standard serial I/O mode, serial data I/O uses the four serial I/O

pins SCLK, RxD, TxD and SRDY1 (BUSY). The SCLK1 pin is the

transfer clock input pin through which an external transfer clock is

input. The TxD pin is for CMOS output. The SRDY1 (BUSY) pin

outputs “L” level when ready for reception and “H” level when re-

ception starts.

Serial data I/O is transferred serially in 8-bit units.

In standard serial I/O mode, only the User ROM area shown in

Figure 44 can be rewritten. The Boot ROM area cannot.

In standard serial I/O mode, a 7-byte ID code is used. When there

is data in the flash memory, commands sent from the peripheral

unit (programmer) are not accepted unless the ID code matches.

Outline Performance (Standard Serial I/O

Mode)

In standard serial I/O mode, software commands, addresses and

data are input and output between the MCU and peripheral units

(serial programmer, etc.) using 4-wire clock-synchronized serial

I/O (serial I/O1).

In reception, software commands, addresses and program data

are synchronized with the rise of the transfer clock that is input to

the SCLK pin, and are then input to the MCU via the RxD pin. In

transmission, the read data and status are synchronized with the

fall of the transfer clock, and output from the TxD pin.

The TxD pin is for CMOS output. Transfer is in 8-bit units with LSB

first.

When busy, such as during transmission, reception, erasing or

program execution, the SRDY1 (BUSY) pin is “H” level. Accord-

ingly, always start the next transfer after the SRDY1 (BUSY) pin is

“L” level.

Also, data and status registers in a memory can be read after in-

putting software commands. Status, such as the operating state of

the flash memory or whether a program or erase operation ended

successfully or not, can be checked by reading the status register.

Here following explains software commands, status registers, etc.

Rev.1.01 Jul 01, 2003 page 61 of 89

Share Link: