LX5510BLQ データシートの表示（PDF） - Microsemi Corporation
部品番号
コンポーネント説明
一致するリスト
LX5510BLQ Datasheet PDF : 8 Pages
| |||
LX5510B
TM
®
InGaP HBT 2.4 – 2.5 GHz Power Amplifier
PRODUCTION DATA SHEET
ABSOLUTE MAXIMUM RATINGS
DC Supply Voltage, RF off ...............................................................................6V
Collector Current ........................................................................................400mA
Total Power Dissipation....................................................................................2W
RF Input Power........................................................................................... 15dBm
Operation Ambient Temperature ...................................................-40°C to +85°C
Storage Temperature....................................................................-65°C to +150°C
Package Peak Temp. for Solder Reflow (40 seconds maximum exposure) ......260°(+0, -5)
Note: Exceeding these ratings could cause damage to the device. All voltages are with respect to
Ground. Currents are positive into, negative out of specified terminal.
THERMAL DATA
LQ Plastic MLPQ 16-Pin
THERMAL RESISTANCE-JUNCTION TO CASE, θJC
THERMAL RESISTANCE-JUNCTION TO AMBIENT, θJA
10°C/W
50°C/W
PACKAGE PIN OUT
VC2
RF OUT
RF OUT
N.C.
13 14 15 16
12
*1
11
2
10
3
9
4
87 65
N.C.
RF IN
RF IN
N.C.
LQ PACKAGE
(Bottom View)
RoHS / Pb-free 100% Matte Tin Lead Finish
Name
RF IN
VB1
VB2
VCC
RF OUT
VC1
VC2
GND
FUNCTIONAL PIN DESCRIPTION
Description
RF input for the power amplifier. This pin is DC-shorted to GND but AC-coupled to the transistor base of the first
stage.
Bias current control voltage for the first stage.
Bias current control voltage for the second stage. The VB2 pin can be connected with the first stage control
voltage (VB1) into a single reference voltage (referred to as VREF) through an external resistor bridge.
Supply voltage for the bias reference and control circuits. This pin can be combined with both VC1 and VC2 pins,
resulting in a single supply voltage (referred to as VC).
RF output for the power amplifier.
Power supply for first stage amplifier. The VC1 feed line should be terminated with a 3.9pF bypass capacitor 50
mil apart from the device, followed by a 8.2nH blocking inductor at the supply side. This pin can be combined
with VC2 and VCC pins, resulting in a single supply voltage (referred to as VC).
Power supply for second stage amplifier. The VC2 feed line should be driven with a 8.2nH AC blocking inductor
and 1µF bypass capacitor. This pin can be combined with VC1 and VCC pins, resulting in a single supply voltage
(referred to as VC).
The center metal base of the MLP package provides both DC and RF ground as well as heat sink for the power
amplifier.
Copyright © 2004
Rev. 1.0d, 2005-08-18
Microsemi
Integrated Products Division
11861 Western Avenue, Garden Grove, CA. 92841, 714-898-8121, Fax: 714-893-2570
Page 2
Share Link: 