LT3980IMSE-TRPBF データシートの表示（PDF） - Linear Technology

部品番号

コンポーネント説明

一致するリスト

LT3980IMSE-TRPBF

58V, 2A, 2.4MHz Step-Down Switching Regulator with 85µA Quiescent Current

Linear Technology 

LT3980

Operation

The LT3980 is a constant frequency, current mode step-

down regulator. An oscillator, with frequency set by RT,

enables an RS flip-flop, turning on the internal power

switch. An amplifier and comparator monitor the current

flowing between the VIN and SW pins, turning the switch

off when this current reaches a level determined by the

voltage at VC. An error amplifier measures the output

voltage through an external resistor divider tied to the FB

pin and servos the VC pin. If the error amplifier’s output

increases, more current is delivered to the output; if it

decreases, less current is delivered. An active clamp on the

VC pin provides current limit. The VC pin is also clamped to

the voltage on the RUN/SS pin; soft-start is implemented

by generating a voltage ramp at the RUN/SS pin using an

external resistor and capacitor.

An internal regulator provides power to the control circuitry.

The bias regulator normally draws power from the VIN pin,

but if the BD pin is connected to an external voltage higher

than 3V bias power will be drawn from the external source

(typically the regulated output voltage). This improves

efficiency. The RUN/SS pin is used to place the LT3980

in shutdown, disconnecting the output and reducing the

input current to less than 0.5µA.

The switch driver operates from either the input or from

the BOOST pin. An external capacitor and diode are used

to generate a voltage at the BOOST pin that is higher than

the input supply. This allows the driver to fully saturate the

internal bipolar NPN power switch for efficient operation.

To further optimize efficiency, the LT3980 automatically

switches to Burst Mode operation in light load situations.

Between bursts, all circuitry associated with controlling

the output switch is shut down, reducing the input supply

current to 75µA in a typical application.

The oscillator reduces the LT3980’s operating frequency

when the voltage at the FB pin is low. This frequency

foldback helps to control the output current during startup

and overload. In addition, the LT3980 monitors the catch

diode current flowing through the DA pin and pauses the

oscillator during overcurrent conditions to keep inductor

current at safe levels.

The LT3980 contains a power good comparator which trips

when the FB pin is at 91% of its regulated value. The PG

output is an open-collector transistor that is off when the

output is in regulation, allowing an external resistor to pull

the PG pin high. Power good is valid when the LT3980 is

enabled and VIN is above 3.6V.

The LT3980 has an overvoltage protection feature which

disables switching action when the VIN goes above 61.5V

typical (58V minimum). When switching is disabled, the

LT3980 can safely sustain input voltages up to 62V.

3980fa

8

For more information www.linear.com/LT3980

Share Link: