TDA8708B データシートの表示（PDF） - Philips Electronics

部品番号

コンポーネント説明

一致するリスト

TDA8708B

Video analog input interface

Philips Electronics 

Philips Semiconductors

Video analog input interface

Product specification

TDA8708B

Notes

1. 0 dB is obtained at the AGC amplifier when applying Vi(p-p) = 1.33 V.

2. The output current at pin 19 should not exceed 1 mA. The load impedance RL should be referenced to VCCA and

defined as:

a) AC impedance ≥1 kΩ and the DC impedance >2.7 kΩ.

b) The load impedance should be coupled directly to the output of the amplifier so that the DC voltage supplied by

the clamp is not disturbed.

3. Control mode 2 is selected.

4. Signal-to-noise ratio measured with 5 MHz bandwidth: N-S-- = 20 log V-----AV---N-A--O--N--U-O--T--U-Y---T-(-R-C---M-(--pS----–-n--op---i)-s--e--) at B = 5 MHz .

5. The voltage ratio is expressed as:

SVRR1 = 20 log∆---V--V--C--C-C---C-A--A- × ∆---G--G--- for VI = 1 V (p-p), gain at 100 kHz = 1 and 1 V supply variation.

6. It is recommended that the rise and fall times of the clock are ≥2 ns. In addition, a ‘good layout’ for the digital and

analog grounds is recommended.

7. These measurements are realized on analog signals after a digital-to-analog conversion (TDA8702 is used).

8. The supply voltage rejection is the relative variation of the analog signal (full-scale signal at input) for 1 V of supply

variation:

SVRR2 = -∆-----(--V----I---(--0--0---)----–----V-----I--(--F---F∆---)-V-)----C-+--C----(A--V-----I--(--0---0--)----–-----V----I--(--F---F---)---)-

9. Full-scale sine wave (fi = 4.4 MHz; fclk = 27 MHz).

1996 Nov 26

9

Share Link: