IS42S81600B-7TI データシートの表示（PDF） - Integrated Silicon Solution
部品番号
コンポーネント説明
一致するリスト
IS42S81600B-7TI Datasheet PDF : 60 Pages
| |||
IS42S81600B, IS42S16800B
ISSI ®
PIN FUNCTIONS
Symbol
A0-A11
Type
Input Pin
BA0, BA1
CAS
CKE
CLK
CS
DQML,
DQMH
Input Pin
Input Pin
Input Pin
Input Pin
Input Pin
Input Pin
DQM
DQ0-DQ7 or
DQ0-DQ15
RAS
WE
VDDQ
VDD
VSSQ
VSS
Input Pin
Input/Output
Input Pin
Input Pin
Power Supply Pin
Power Supply Pin
Power Supply Pin
Power Supply Pin
Function (In Detail)
Address Inputs: A0-A11 are sampled during the ACTIVE
command (row-address A0-A11) and READ/WRITE command (column address A0-A9
(x8), or A0-A8 (x16); with A10 defining auto precharge) to select one location out of the
memory array in the respective bank. A10 is sampled during a PRECHARGE command
to determine if all banks are to be precharged (A10 HIGH) or bank selected by
BA0, BA1 (LOW). The address inputs also provide the op-code during a LOAD MODE
REGISTER command.
Bank Select Address: BA0 and BA1 defines which bank the ACTIVE, READ, WRITE or
PRECHARGE command is being applied.
CAS, in conjunction with the RAS and WE, forms the device command. See the
"Command Truth Table" for details on device commands.
The CKE input determines whether the CLK input is enabled. The next rising edge of the
CLK signal will be valid when is CKE HIGH and invalid when LOW. When CKE is LOW,
the device will be in either power-down mode, clock suspend mode, or self refresh
mode. CKE is an asynchronous input.
CLK is the master clock input for this device. Except for CKE, all inputs to this device
are acquired in synchronization with the rising edge of this pin.
The CS input determines whether command input is enabled within the device.
Command input is enabled when CS is LOW, and disabled with CS is HIGH. The device
remains in the previous state when CS is HIGH.
DQML and DQMH control the lower and upper bytes of the I/O buffers. In read
mode,DQML and DQMH control the output buffer. WhenDQML orDQMH is LOW, the
corresponding buffer byte is enabled, and when HIGH, disabled. The outputs go to the
HIGH impedance state whenDQML/DQMH is HIGH. This function corresponds to OE
in conventional DRAMs. In write mode,DQML and DQMH control the input buffer. When
DQML or DQMH is LOW, the corresponding buffer byte is enabled, and data can be
written to the device. WhenDQML or DQMH is HIGH, input data is masked and cannot
be written to the device. For IS42S16800B only.
For IS42S81600B only.
Data on the Data Bus is latched on DQ pins during Write commands, and buffered for
output after Read commands.
RAS, in conjunction with CAS and WE, forms the device command. See the "Command
Truth Table" item for details on device commands.
WE, in conjunction with RAS and CAS, forms the device command. See the "Command
Truth Table" item for details on device commands.
VDDQ is the output buffer power supply.
VDD is the device internal power supply.
VSSQ is the output buffer ground.
VSS is the device internal ground.
Integrated Silicon Solution, Inc. — www.issi.com — 1-800-379-4774
5
Rev. E
05/01/06
Share Link: 