HR30(2004) データシートの表示（PDF） - HIROSE ELECTRIC
部品番号
コンポーネント説明
一致するリスト
HR30 Datasheet PDF : 12 Pages
| |||
Cable
Push/pull
locking collar
A
Plug insulator body
Cable
Back shell
Guide keys
View A (2:1)
Cable
Tightening collar for back shell
Solder termination fixture
3
Groove - sealing bushing
Front edge of cable jacket
Figure B
Figure C
Connector
3 and 6 Pos.
10 and 12 Pos.
Back shell tightening collar size
16 mm
18 mm
Torque
0.5N.m
0.5N.m
1. To prevent accidental loosening of the back shell it is recommended that a small amount of primer (Loctite® 7649) and
adhesive (Loctite® 271) be applied to the threads of the insulator body before proceeding.
2. Keeping the terminated insulator body on the fixture, re-assembly the plug in order shown.
4. Using the correct back-tightening collar tighten the back shell to the specified torque.
When tightening the collar make sure that the cable will NOT turn.
5. Remove the assembly from the fixture.
Note: Loctite is a registered trademark of the Henkel Loctite Corporation.
11
Share Link: 