AMS1510CT-3.3 データシートの表示（PDF） - Advanced Monolithic Systems Inc

部品番号

コンポーネント説明

一致するリスト

AMS1510CT-3.3

10A LOW DROPOUT VOLTAGE REGULATORS

Advanced Monolithic Systems Inc 

AMS1510

ELECTRICAL CHARACTERISTICS

Electrical Characteristics at IOUT = 0 mA, and TJ = +25°C unless otherwise specified.

Parameter

Device

Conditions

Min Typ Max Units

Dropout Voltage

Note 2

Control Dropout

(VCONTROL - VOUT)

Power Dropout

(VPOWER - VOUT)

AMS1510/-1.5/-2.5/

-2.85/-3.0/-3.3/-3.5/-5.0

AMS1510/-1.5/-2.5/

-2.85/-3.0/-3.3/-3.5/-5.0

VPOWER =VOUT + 0.8V, ILOAD = 10mA

VPOWER =VOUT + 0.8V, ILOAD = 10A

VCONTROL =VOUT + 2.5V, ILOAD = 10mA

VCONTROL =VOUT + 2.5V, ILOAD = 10A

1.00

1.15

V

1.15

1.30

V

.10

0.17

V

.45

0.60

V

Parameters identified with boldface type apply over the full operating temperature range.

Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. For guaranteed specifications and test conditions, see the

Electrical Characteristics. The guaranteed specifications apply only for the test conditions listed.

Note 2: Unless otherwise specified VOUT = VSENSE. For the adjustable device VADJ = 0V.

Note 3: The dropout voltage for the AMS1510 is caused by either minimum control voltage or minimum power voltage. The specifications represent the minimum

input/output voltage required to maintain 1% regulation.

Note 4: For the adjustable device the minimum load current is the minimum current required to maintain regulation. Normally the current in the resistor divider

used to set the output voltage is selected to meet the minimum load current requirement.

Note 5: The control pin current is the drive current required for the output transistor. This current will track output current with a ratio of about 1:100. The

minimum value is equal to the quiescent current of the device.

PIN FUNCTIONS

Sense (Pin 1): This pin is the positive side of the

reference voltage for the device. With this pin it is

possible to Kelvin sense the output voltage at the load.

Adjust (Pin 2/5): This pin is the negative side of the

reference voltage for the device. Adding a small bypass

capacitor from the Adjust pin to ground improves the

transient response. For fixed voltage devices the Adjust

pin is also brought out to allow the user to add a bypass

capacitor.

GND (Pin 2, 7-Lead only): For fixed voltage devices this

is the bottom of the resistor divider that sets the output

voltage.

VPOWER (Pin 5/6): This pin is the collector to the power

device of the AMS1510. The output load current is

supplied through this pin. The voltage at this pin must

be between 0.1V and 0.8V greater than the output

voltage for the device to regulate.

VCONTROL (Pin 4/3): This pin is the supply pin for the

control circuitry of the device. The current flow into

this pin will be about 1% of the output current. The

voltage at this pin must be 1.3V or greater than the

output voltage for the device to regulate.

Output (Pin 3/4): This is the power output of the

device.

Advanced Monolithic Systems, Inc. 6680B Sierra Lane, Dublin, CA 94568 Phone (925) 556-9090 Fax (925) 556-9140

Share Link: