HDMIULC6-4SC6 データシートの表示（PDF） - STMicroelectronics

部品番号

コンポーネント説明

一致するリスト

HDMIULC6-4SC6

Ultra large bandwidth ESD protection

STMicroelectronics 

Technical information

HDMIULC6-4SC6

Figure 12. Remaining voltage after the

HDMIULC6-4SC6 during

positive ESD surge

Figure 13. Remaining voltage after the

HDMIULC6-4SC6 during

negative ESD surge

Note:

The measurements have been done with the HDMIULC6-4SC6 in open circuit.

IMPORTANT:

An important precaution to take is to put the protection device as close as possible to the

disturbance source (generally the connector).

3.4

Crosstalk behavior

Figure 14. Crosstalk phenomena

RG1

VG1

RG2

VG2

Line 1

Line 2

RL1

α1VG1 + β12VG2

RL2

α 2VG2 + β21VG1

DRIVERS

RECEIVERS

The crosstalk phenomena is due to the coupling between 2 lines. The coupling factor (β12 or

β21) increases when the gap across lines decreases, particularly in silicon dice. In the

example above the expected signal on load RL2 is α2VG2, in fact the real voltage at this point

has got an extra value β21VG1. This part of the VG1 signal represents the effect of the

crosstalk phenomenon of the line 1 on the line 2. This phenomenon has to be taken into

account when the drivers impose fast digital data or high frequency analog signals in the

disturbing line. The perturbed line will be more affected if it works with low voltage signal or

high load impedance (few kΩ).

8/11

Share Link: