GS-R51212S データシートの表示（PDF） - STMicroelectronics
部品番号
コンポーネント説明
一致するリスト
GS-R51212S Datasheet PDF : 8 Pages
| |||
Figure 3 - Typical Application.
GS-R51212S/GS-R51515S
Inhibit/Enable Input
The Inhibit/Enable function allows the ON/OFF
logic control of the module.
The converter is ON (Enable) when the voltage
applied to pin 2 (EN.) and referred to pin 1 (GND
IN) is lower than 0.8V (TTL, CMOS, open collector
compatible level).
The converter is OFF (Inhibit) when pin 2 is uncon-
nected or the voltage applied is in the range of 1.2V
to +Vin. Maximum sinking current is 1mA.
Module Protection
The module is protected against occasional and
permanent short-circuits of the output pins to
ground, as well as against output current overload.
The main output (+5.1V) uses a foldback current
limiting; the output current decreases with increas-
ing overload, reaching a minimum at short-circuit
condition.
This solution minimizes internal power dissipation.
The auxiliary outputs (±12V or ±15V) use a current
limiting protection circuitry.
Thermal characteristics
Sometimes the GS-R51212S and GS-R51515Sre-
quire an external heat-sink depending on both op-
erating temperature conditions and power.
Before entering into calculations details, some ba-
sic concepts will be explained to better understand
the problem.
The thermal resistance between two points is rep-
resented by their temperature difference in front of
a specified dissipated power, and it is expressed in
Degree Centigrade per Watt (°C/W).
For the modules the thermal resistance case to
ambient is 7.5°C/W. This means that an internal
power dissipationof 1W will bring the case tempera-
ture at 7.5°C above the ambient temperature.
The maximum case temperature is 85°C.
Let’s suppose to have a GS-R51515S that delivers
the maximum output power of 31.4W at an ambient
temperature of 40°C.
7/8
Share Link: 