CXA2534Q データシートの表示（PDF） - Sony Semiconductor

部品番号

コンポーネント説明

一致するリスト

CXA2534Q

4-Channel CD Motor Driver

Sony Semiconductor 

CXA2534Q

c) Soft Start

During start-up of the IC, the duty cycle of the DC-to-DC converter is increased slowly to a maximum of

80 %. The VCC1 voltage will also increase slowly. This is known as soft start.

During the soft start, the duty cycle of the SW pin (pin 40) is dependent on the voltage at the DEAD pin

(pin 41). The DEAD pin is connected to a capacitor which is being charged up by an internal resistance

of 65 kΩ. Therefore, the time taken for the duty cycle to reach the maximum is

t = CSPRT × R

(sec)

where R = 65 kΩ

d) Power Off

To turn off the DC-to-DC Converter, a LOW level is applied to the OFF pin (pin 26). When the OFF pin

is low, the IC will not turn off the DC-to-DC converter immediately but will charge up the SPRT pin’s

capacitor with a constant current of 20 µA. Once the SPRT pin’s voltage is above 1.23 V, the IC will

then shut down. Therefore, the delay is given by the formula below:

1.23 V

t=

× CSPRT (sec)

20 µA

e) Over-Voltage Protection

The IC will detect a over-voltage if the voltage at the BSEN pin is above 8.4 V (typical). When over-

voltage occurred, the IC will shut down after a time delay. The time delay is determined by the time

taken for the SPRT pin’s capacitor to charge above 1.23 V. The charging current for the SPRT pin

capacitor is constant and is 20 µA.

1.23 V

t=

× CSPRT (sec)

20 µA

f) Reset Pulse

When the VCC1 voltage rises above 90 % of the designed value, the RESET pin (pin 25) will change

from LOW level to HIGH level. A hysteresis of 50 mV (typical) is implemented to prevent the ‘chattering’

of the output at RESET pin.

g) Empty Detection

The EMP pin (pin 24) is used to indicate low battery voltage. When the BSEN pin falls below a certain

threshold voltage, the EMP pin will change from HIGH to LOW level. There are two threshold voltages,

depending on the SEL pin (pin 37). In order to prevent ‘chattering’ of the output at the EMP pin, a

hysteresis of 50 mV (typical) is implemented.

SEL pin

LOW

High - Z

Threshold Voltage

(typical)

2.0 V

1.6 V

Recovery Voltage

(typical)

2.05 V

1.65 V

—21—

Share Link: