ELM331 データシートの表示（PDF） - Elm Electronics
部品番号
コンポーネント説明
一致するリスト
ELM331 Datasheet PDF : 4 Pages
| |||
ELM331
Absolute Maximum Ratings
Storage Temperature....................... -65°C to +150°C
Ambient Temperature with
Power Applied....................................-40°C to +85°C
Voltage on VDD with respect to VSS............ 0 to +7.5V
Voltage on any other pin with
respect to VSS........................... -0.6V to (VDD + 0.6V)
Note:
Stresses beyond those listed here will likely damage
the device. These values are given as a design
guideline only. The ability to operate to these levels
is neither inferred nor recommended.
Electrical Characteristics
All values are for operation at 25°C and a 5V supply, unless otherwise noted. For further information, refer to note 1 below.
Characteristic
Minimum Typical Maximum Units
Conditions
Supply Voltage, VDD
3.0
5.0
5.5
V
VDD rate of rise
0.05
V/ms see note 2
Average Supply Current, IDD
1.0
2.4
mA VDD = 5V, see note 3
0.6
2.4
mA VDD = 3V, see note 3
Frequency of measurements
2.0
sec see note 4
Reset pin internal pullup resistance
300
470
600
KΩ see note 5
R1C or R2C time constant
500
500,000
µs see note 6
Input low voltage - reset pin
VSS
0.15 VDD
V
Input high voltage - reset pin
0.85 VDD
VDD
V
Output low voltage
0.6
V Current (sink) = 8.7mA
Output high voltage
VDD - 0.7
V Current (source) = 5.4mA
Notes: 1. This integrated circuit is produced with a Microchip Technology Inc.’s PIC12C5XX as the core embedded
microcontroller. For further device specifications, and possibly clarification of those given, please refer to the
appropriate Microchip documentation.
2. This spec must be met in order to ensure that a correct power on reset occurs. It is quite easily achieved
using most common types of supplies, but may be violated if one uses a slowly varying supply voltage, as
may be obtained through direct connection to solar cells, or some charge pump circuits.
3. Device only. Does not include any LED or drive currents.
4. If a measured resistance is determined to be out of limits, the frequency of measurements is increased to
provide visual feedback as well as a faster recovery.
5. The value of the pullup resistance is supply and temperature dependent.
6. One should also maintain R1 and R2 to not less than about 5KΩ. When C is chosen, select the pin 5 current
limiting resistance so that RLIMC is less than 1msec, and RLIM is greater than 1KΩ.
ELM331DSB
Elm Electronics – Circuits for the Hobbyist
< http://www.elmelectronics.com/ >
3 of 4
Share Link: 