RTL8201 データシートの表示（PDF） - Realtek Semiconductor

部品番号

コンポーネント説明

一致するリスト

RTL8201

REALTEK SINGLE CHIP SINGLE PORT 10/100MBPS FAST ETHERNET PHYCEIVER

Realtek Semiconductor 

RTL8201(L)

7. Functional Description

The RTL8201(L) Phyceiver is a physical layer device that integrates 10Base-T and 100Base-TX functions and some extra

power manage features into a 48 pin single chip which is used in 10/100 Fast Ethernet applications. This device supports the

following functions:

MII interface with MDC/MDIO management interface to communicate with MAC

IEEE 802.3u clause 28 Auto-Negotiation ability

Flow control ability support to cooperate with MAC

Speed, duplex, auto-negotiation ability configurable by hard wire or MDC/MDIO.

Flexible LED configuration.

7-wire SNI(Serial Network Interface) support, works only on 10Mbps mode.

Power Down mode support

4B/5B transform

Scrambling/De-scrambling

NRZ to NRZI, NRZI to MLT3

Manchester Encode and Decode for 10 BaseT operation

Clock and Data recovery

Adaptive Equalization

7.1 MII and Management Interface

To set the RTL8201(L) for MII mode operation, pull MII/SNIB pin high and properly set the ANE, SPEED, and DUPLEX

pins.

The MII (Media Independent Interface) is an 18-signal interface which is described in IEEE 802.3u supplying a standard

interface between PHY and MAC layer. This interface operates in two frequencies – 25Mhz and 2.5Mhz to support

100Mbps/10Mbps bandwidth for both the transmit and receive function. While transmitting packets, the MAC will first assert

the TXEN signal and change byte data into 4 bits nibble and pass to the PHY by TXD[0..3]. PHY will sample TXD[0..]

synchronously with TXC — the transmit clock signal supplied by PHY – during the interval TXEN is asserted. While

receiving a packet, the PHY will assert the RXEN signal, pass the received nibble data RXD[0..3] clocked by RXC, which is

recovered from the received data. CRS and COL signals are used for collision detection and handling.

The MAC layer device can control PHY by the MDC/MDIO management interface, but for proper operation, the PHY address

needs to be well configured so the management command can be delivered to the PHY. The MDC can be software generated

to clock the 1 bit serial data stream to/from the MDIO to access the registers of the PHY.

In 100Base-TX mode, when decoded signal in 5B is not IDLE, the CRS signal will assert and when 5B is recognized as IDLE

it will be de-asserted. In 10Base-T mode, CRS will assert when the 10M preamble been confirmed and will be de-asserted

when the IDLE pattern been confirmed.

The RXDV signal will be asserted when decoded 5B are /J/K/and will be deasserted if the 5B are /T/R/or IDLE in 100Mbps

mode. In 10Mbps mode, the RXDV signal is the same as the CRS signal.

The RTL8201(L) does not use the TXER signal and will not affect the transmit function.

2002-01-18

17

Rev.1.04

Tel: +49(0)234-9351135 · Fax: +49(0)234-9351137 E-MAIL: info@cornelius-consult.de

http://www.cornelius-consult.de

Share Link: