AS1112 データシートの表示（PDF） - austriamicrosystems AG

部品番号

コンポーネント説明

一致するリスト

AS1112

16-Channel LED Driver with Dot Correction and Greyscale PWM

austriamicrosystems AG 

AS1112

Datasheet - Detailed Description

Figure 8. Error Detection Timing (GS=FFFFHEX, DC=3FHEX)

LD

OEN

>1µs

GSCLK

SID

LODn, LSDn

LODn+1, LSDn+1

Error

Detection

Start

Error

Detection

End

Note: The rising edge of LD latches new data into the internal registers depending on the logic level of the pin

MODE. If the pin MODE is tied GND, the greyscale registers are updated. If the pin MODE is tied to VCC, the

dot correction registers are updated.

Delay Between Outputs

The AS1112 uses graduated delay circuits between OUTn outputs. These circuits are contained in the constant-current

driver block of the AS1112 (see Figure 1 on page 1). The average-delay time is 30ns (typ).

The maximum delay is 450ns (typ) from OUT0 to OUT15. The delay scheme works by switching on and switching off

each output channel. Thus the on/off time of each channel is the same regardless of the delay. These delays prevent

large inrush currents and switching noise that can reduce bypass capacitance when the outputs are switched on.

OUTn Enable

All OUTn channels can be collectively switched off with one signal. When OEN is set to 1, all OUTn channels are dis-

abled, regardless of the device logic operations. The greyscale counter is also reset when OEN is set to 1.

When OEN is set to 0, all OUTn channels are in normal operation.

Table 10. Pin OEN Truth Table

OEN

OUT0:OUT15

0

Normal Operation

1

Disabled

Setting Maximum Channel Current

The maximum output current per channel is programmed by a single resistor, RIREF, which is placed between pin IREF

and GND. The voltage on pin IREF is set by an internal band gap VIREF (1.24V typ). The maximum channel current is

equivalent to the current flowing through RIREF multiplied by a factor of 31.5. The maximum output current is calculated

as:

IMAX = VIREF x 31.5

RIREF

(EQ 1)

Where:

VIREF = 1.24V;

RIREF = User-selected external resistor.

Figure 5 on page 7 shows the maximum output current IOUT versus RIREF, where RIREF is the value of the resistor

between IREF terminal to GND, and IOUT is the constant output current of OUT0:OUT15.

www.austriamicrosystems.com

Revision 1.06

10 - 18

Share Link: