PM75DSA120_ データシートの表示（PDF） - MITSUBISHI ELECTRIC
部品番号
コンポーネント説明
一致するリスト
PM75DSA120_ Datasheet PDF : 31 Pages
| |||
MITSUBISHI SEMICONDUCTORS POWER MODULES MOS
USING INTELLIGENT POWER MODULES
6.2.1 Maximum Ratings
Symbol
Parameter
Inverter Part
VCC
VCES
±IC
±ICP
PC
Tj
Supply Voltage
Collector-Emitter Voltage
Collector-Current
Collector-Current (peak)
Collector Dissipation
Junction Temperature
Brake Part
VR(DC)
IF
FWDi Reverse Voltage
FWDi Forward Current
Control Part
VD
VCIN
VFO
IFO
Supply Voltage
Input Voltage
Fault Output Supply Voltage
Fault Output Current
Total System
VCC(prot)
Supply Voltage Protected
by OC & SC
TC
Module Case Operating
Temperature
Tstg
Storage Temperature
Viso
Isolation Voltage
Definition
Maximum DC bus voltage applied between P-N
Maximum off-state collector-emitter voltage at applied control input off signal
Maximum DC collector and FWDi current @ Tj ≤ 150°C
Maximum peak collector and FWDi current @ Tj ≤ 150°C
Maximum power dissipation per IGBT switch at Tj = 25°C
Range of IGBT junction temperature during operation
Maximum reverse voltage of FWDi
Maximum FWDi DC current at Tj ≤ 150°C
Maximum control supply voltage
Maximum voltage between input (I) and ground (C) pins
Maximum voltage between fault output (FO) and ground (C) pins
Maximum sink current of fault output (FO) pin
Maximum DC bus voltage applied between P-N with guaranteed OC and SC protection
Range of allowable case temperature at specified reference point during operation
Range of allowable ambient temperature without voltage or current
Maximum isolation voltage (AC 60Hz 1 min.) between baseplate and module terminals
(all main and signal terminals externally shorted together)
6.2.2 Thermal Resistance
Symbol
Rth(j-c)
Rth(c-f)
Parameter
Junction to Case
Thermal Resistance
Contact Thermal
Resistance
Definition
Maximum value of thermal resistance between junction and case per switch
Maximum value of thermal resistance between case and fin (heatsink) per IGBT/FWDi pair
with thermal grease applied according to mounting recommendations
6.2.3 Electrical Characteristics
Symbol
Parameter
Inverter and Brake Part
VCE(sat)
Collector-Emitter
Saturation Voltage
VEC
ton
trr
tc(on)
toff
tc(off)
ICES
FWDi Forward Voltage
Turn-On Time
FWDi Recovery Time
Turn-On Crossover Time
Turn-Off Time
Turn-Off Crossover Time
Collector-Emitter Cutoff
Definition
IGBT on-state voltage at rated collector current under specified conditions
FWDi forward voltage at rated current under specified conditions
Inductive load switching times under rated conditions
(See Figure 6.10)
Collector-Emitter current in off-state at VCE = VCES under specified conditions
Sep.1998
Share Link: 