10XS3535 データシートの表示（PDF） - Freescale Semiconductor
部品番号
コンポーネント説明
一致するリスト
10XS3535 Datasheet PDF : 45 Pages
| |||
ELECTRICAL CHARACTERISTICS
STATIC ELECTRICAL CHARACTERISTICS
STATIC ELECTRICAL CHARACTERISTICS
Table 3. Static Electrical Characteristics
Characteristics noted under conditions 3.0 V ≤ VCC ≤ 5.5 V, 7.0 V ≤ VBAT ≤ 2 0V, -40 °C ≤ TA ≤ 125 °C, GND = 0 V, unless
otherwise noted. Typical values noted reflect the approximate parameter means at TA = 25 °C under nominal conditions, unless
otherwise noted.
Characteristic
Symbol
Min
Typ
Max
Unit
POWER INPUTS (VBAT, VCC)
Battery Supply Voltage Range
Full Performance & Short Circuit
Extended Voltage Range(6)
VBAT
7.0
6.0
Battery Supply Under-voltage (UV flag is set ON)
Battery Supply Over-voltage (OV flag is set ON)
Battery Voltage Clamp(9)
Battery Supply Power on Reset(10)
VBATUV
VBATOV
VBATCLAMP
5.0
27.5
40
If VBAT < 5.5 V, VBAT = VCC
If VBAT < 5.5 V, VCC = 0
VBATPOR1
2.0
VBATPOR2
2.0
VBAT Supply Current @ 25 °C and VBAT = 12 V and VCC = 5 V
Sleep State Current, Outputs Opened
Sleep State Current, Outputs Grounded
Normal Mode, IGN = 5 V, RST = 5 V, Outputs Open
Digital Supply Voltage Range, Full Performance
Digital Supply Undervoltage (VCC Failure)
Sleep Current Consumption on VCC @ 25 °C and VBAT = 12 V
Output OFF
IBATSLEEP1
–
IBATSLEEP2
–
IBAT
–
VCC
3.0
VCCUV
2.2
ICCSLEEP
–
Supply Current Consumption on VCC and VBAT = 12 V
No SPI
3.0 MHz SPI Communication
ICC
–
–
LOGIC INPUT/OUTPUT (IGN, CS, CSNS, SI, SCLK, CLOCK, SO, FLASHER, RST, LIMP, FOG)
Input High Logic Level(7)
Input Low Logic Level(7)
VIH
2.0
VIL
–
Voltage Threshold for wake-up (IGN, FLASHER, FOG and RST)
VIGNTH
1.0
Input Clamp Voltage (IGN, FLASHER, LIMP, FOG, CS, SCLK, SI, RST)
VCL_POS
I = 1.0 mA
7.5
Input Forward Voltage (IGN, FLASHER, LIMP, FOG, CS, SCLK, SI, RST)
VCL_NEG
I = -1.0 mA
- 2.0
Input Passive Pull-up Resistance on CS input(8)
RUP
100
Input Passive Pull-down Resistance on SI, SCLK, FLASHER, IGN, FOG,
RDWN
100
CLOCK, LIMP and RST pins(8)
SO High-state Output Voltage
IOH = 1.0 mA
VSOH
0.8
SO Low-state Output Voltage
IOL = -1.6 mA
VSOL
–
CLOCK Output Voltage reporting wake-up event (ICLOCK = 1.0 mA)
VCLOCKH
0.8
Notes
6. In extended mode, the functionality is guaranteed but not the electrical parameters.
7. Valid for RST, SI, SCLK, CS, CLOCK, IGN, FLASHER, FOG, and LIMP pins.
8. Valid for the following input voltage range: -0.3 V to VCC + 0.3 V.
9. Outputs shorted to ground, IOUT = + 500 mA and IOUT =OCHI (guaranteed by design).
10. Please refer to Loss of Supply Lines section for more details.
–
–
5.5
30
–
–
–
0.5
0.5
10.0
–
2.5
0.2
–
–
–
–
–
–
–
200
200
0.95
0.2
0.95
V
20.0
28.0
6.0
V
32.5
V
48
V
V
3.0
4.0
5.0
μA
5.0
μA
20.0
mA
5.5
V
2.8
V
μA
5.0
mA
2.6
5.0
–
V
0.8
V
2.2
V
V
13
V
-0.3
400
kΩ
500
kΩ
–
VCC
V
0.4
–
Vcc
Analog Integrated Circuit Device Data
Freescale Semiconductor
10XS3535
7
Share Link: 