6N137STB データシートの表示（PDF） - EVERLIGHT

部品番号

コンポーネント説明

一致するリスト

6N137STB

8 PIN DIP HIGH SPEED 10MBit/s LOGIC GATE PHOTOCOUPLER

EVERLIGHT 

8 PIN DIP HIGH SPEED 10MBit/s LOGIC GATE

6N137

PHOTOCOUPLER

EL26XX series

Notes:

*3 The VCC supply must be bypassed by a 0.1µF capacitor or larger. This can be either a ceramic or solid

tantalum capacitor with good high frequency characteristic and should be connected as close as possible to

the package VCC and GND pins

– *4. Enable Input – No pull up resistor required as the device has an internal pull up resistor.

*5. tPLH Propagation delay is measured from the 3.75mA level on the HIGH to LOW transition of the input

– current pulse to the 1.5 V level on the LOW to HIGH transition of the output voltage pulse.

*6. tPHL Propagation delay is measured from the 3.75mA level on the LOW to HIGH transition of the input

–current pulse to the 1.5 V level on the HIGH to LOW transition of the output voltage pulse.

*7. tr Rise time is measured from the 90% to the 10% levels on the LOW to HIGH transition of the output

–pulse.

*8. tf Fall time is measured from the 10% to the 90% levels on the HIGH to LOW transition of the output

– pulse.

*9. tELH Enable input propagation delay is measured from the 1.5V level on the HIGH to LOW transition of

– the input voltage pulse to the 1.5V level on the LOW to HIGH transition of the output voltage pulse.

*10. tEHL Enable input propagation delay is measured from the 1.5V level on the LOW to HIGH transition of

the input voltage pulse to the 1.5V level on the HIGH to LOW transition of the output voltage pulse.

*11 CMH– The maximum tolerable rate of rise of the common mode voltage to ensure the output will remain in

the HIGH state (i.e., VOUT > 2.0V).

*12 CML– The maximum tolerable rate of rise of the common mode voltage to ensure the output will remain in

the LOW output state (i.e., VOUT < 0.8V).

Order Information

Part Number

6N137Y(Z)-V

Or

EL26XXY(Z)-V

Note

X = (01 or 11) for EL26 part no.

Y = Lead form option (S, S1, M or none)

Z = Tape and reel option (TA, TB or none).

V = VDE (optional)

Option

None

M

S (TA)

S (TB)

S1 (TA)

S1 (TB)

Description

Standard DIP-8

Wide lead bend (0.4 inch spacing)

Surface mount lead form + TA tape & reel option

Surface mount lead form + TB tape & reel option

Surface mount lead form (low profile) + TA tape & reel option

Surface mount lead form (low profile) + TB tape & reel option

Packing quantity

45 units per tube

45 units per tube

1000 units per reel

1000 units per reel

1000 units per reel

1000 units per reel

： Everlight Electronics Co., Ltd.

Document No DPC-0000120 Rev. 2

9

http://www.everlight.com

November 2, 2011

Share Link: