AD5820 データシートの表示（PDF） - Analog Devices
部品番号
コンポーネント説明
一致するリスト
AD5820 Datasheet PDF : 6 Pages
| |||
AD5820 Evaluation System QuickStart Guide
Introduction
Welcome to the AD5820 Evaluation System. Please follow the steps below to get your
evaluation systems up and running.
Before you connect your evaluation board to the PC please ensure that the AD5820
Evaluation Software has been installed. This will install the necessary evaluation
software and also ensure that the PC will recognize the evaluation board when it is
connected via the USB port.
Software Installation
Install the AD5820 evaluation software version 1.0 using the attached CD. After inserting
the CD, the “AutoRun” software should install the software for you. If this does not
happen, then ‘double-click’ the installer\setup.exe file to install LabView based
evaluation software. You are now ready to connect the evaluation board to the PC via the
USB port.
Hardware Setup
Please refer to Figure 1 below for evaluation board setup.
If the jumpers are set as in figure 1 below, the AD5820 will be powered from the USB
port.
Alternate Load
Connection if
Required
VCM or Ammeter
Connection
USB
Connection
Share Link: 